Brother HL-L2300D Service Manual page 141

(4) Release the registration front/rear sensor PCB harness and the LVPS harness from the
securing fixtures.
(5) Remove the taptite cup S M3x6 SR screw and the two taptite bind B M4x12 screws, and
remove the main frame R ASSY. Pull out the registration front/rear sensor PCB harness
from the hole.
Hole
Harness routing: Refer to
Assembling Note:
• When attaching the main frame R ASSY, check that the LVPS FG plate is set to the
main frame R ASSY.
Registration front/rear sensor PCB harness
Main frame R ASSY
Hole
<Bottom side>
Taptite bind B M4x12
Fig. 3-51
"1. Right side of the machine"
3-48
Taptite bind B M4x12
Taptite cup S M3x6 SR
LVPS FG plate
and "2. Top side of the registration
LVPS harness
<Back side>
<Overhead view
of frame R>
chute".
Confidential