Brother HL-L2300D Service Manual page 142

(6) Remove the taptite bind B M3x10 screw. Release the each hook, and remove the
registration front/rear actuator holder ASSY from the registration chute. Pull out the
registration front/rear sensor PCB harness from the hole.
Registration front/rear
sensor PCB harness
Hole
Harness routing: Refer to
Assembling Note:
• After assembling the registration front/rear actuator holder ASSY to the registration
chute, push the actuators by fingers and check if it is pushed back by its spring (if the
spring is not caught at assembling).
<Top side>
Taptite bind B M3x10
Hook
Hook
<Bottom side>
Fig. 3-52
"2. Top side of the registration
Registration chute
Fig. 3-53
3-49
Registration front/rear
actuator holder ASSY
Hook
Registration chute
chute".
Actuators
Confidential