Maytag WU100 Manual page 71

4. Carefully lay dishwasher on its left side 5. Remove four screws (two on each side)
and roll dishwasher one-fourth turn so it securing base frame to tub support.
is laying on its back. CAUTION: Do not
tip dishwasher dlrectly to its back as
6. Remove three nuts securing each tub
this can result in damage to the support to tub.
blower assembly and tub.
COMPONENTS OF TUB SUPPORT ASSEMBLY
FRONT AND REAR LEVELING LEGS (wu MoDELS)
The leveling legs on undercounter (WU) models provide a means of adjusting the dishwasher
both vertically and horizontally. Convertible (WC) models have no means for leveling.
The front leveling legs are threaded into the base frame and are secured from moving through a
nut which is threaded onto the leg. Once this nut is loosened, the leg can be adjusted up or down
u s i n g a 1 1 4 " r a t c h e t .
The rear leveling legs are secured to the tub support by a pin and fastener and by the adjusting
nut and bolt for the rear leg. NOTE: The rear leveling leg adjustment bolt is located directly behind
t h e f r o n t l e v e l i n g l e g . W h i l e a f l a t b l a d e s c r e w d r i v e r c a n b e u s e d , a 5 / 1 6 " n u t d r i v e r i s
recommended for turning the adjustment bolt.
Refer to the installation instructions provided with each dishwasher for information regarding
p r o p e r l e v e l i n g o f t h e d i s h w a s h e r .
To Remove Front Leveling Legs:
1. Remove 4 screws holding access and
2. Carefully lay dishwasher on its left side
toe panels. Refer to @ Front Panel,
and roll dishwasher one-fourth turn so it
Access Panel And Toe Panel, as
is laying on its back. CAUTION: Do not
needed.
tip dlshwasher dlrectly on lts back as
this can result in damage to the
2. Remove nut from leveling leg.
blower assembly and tub.
3 . C a r e f u l l y l a y d i s h w a s h e r o n i t s l e f t s i d e
3 . R e m o v e c l i p f a s t e n e r f r o m p i n h o l d i n g
and roll dishwasher one-fourth turn so it
leveling leg to tub support and remove
is laying on its back. CAUTION: Do not
pin.
tip dishwasher directly to its back as
this can result in damage to the
4. Remove adjusting bolt from adjusting nut
blower assembty and tub.
and remove nut. The rear leveling leg will
come off when the nut is removed.
4. Unscrew leveling leg from base frame.
To Remove Rear Leveling Legs:
H I N G E P I N
1. Remove 4 screws holdinq access and
toe panels. Refer to @"Front Panel,
Access Panel And Toe Panel. as
Each door hinge rides on a pin attached
needed.
to the tub support assembly.
3 - 1 3