Maytag WU100 Manual page 59

Sectfion C
Senvf,ac Fnoccduncs
MI\YTAG
The control panel assembly holds various electrical and mechanical components. Regardless of
t h e m o d e l , a l l c o n t r o l p a n e l s a r e r e m o v e d f r o m t h e d o o r i n t h e s a m e m a n n e r .
2. Remove four screws which secure
control panel to door. Note there is a
plastic washer on each screw. This
washer is designed to act as a cushion to
reduce the chance of porcelain damage
w h e n t h e s c r e w i s t i g h t e n e d .
When leaving wires attached to electrical
components, some support should be pro-
v i d e d t o t h e c o n t r o l p a n e l a s s e m b l y . T h i s w i l l
prevent damage to terminals, receptacles or
w i r i n g .
Also, to reduce the chance of damage to the
f r o n t p a n e l , a c l o t h , t o w e l , e t c . , s h o u l d b e
draped from the door panel or the front panel
should be removed
lf the control panel is to be completely
removed from the dishwasher, remove all
wires from electrical components and unplug
the green ground wire f rom receptacle
located on the control panel.
NOTE: Early Model "00" dishwashers used
five screws to secure the control panel to the
door. The fifth screw was located in the top of
the center of the door.
To Remove Control Panel Assembly:
CAUTION: Always shut off electrical
power
to the dishwasher before
beginning any service procedure.
1 . R e m o v e d o o r l a t c h k n o b . R e f e r t o @
3-1
Door Latch Assembly as needed.