Hydraulic Connection - ACV LCA HP 2000 mh Technical Manual

 The appliance must be as close as possible to the supply stations.
 For operations of maintenance or replacement of heating components, easy
access must be provided. (Fig 1)
 Installation of raising feet (using the bolts provided) (Fig 2)


Either use of the lifting rings of the appliance (at the top of the appliance),
Or possibility of tilting the appliance (without lying it down), taking care not to
put stress on the cylinder of the tank and of course without impact.
For information any external marking may entail internal damage to the

appliance and will therefore invalidate the warranty.

Position the water heater in its final position.
Check the stability of the water heater.
3.

HYDRAULIC CONNECTION

To enable optimal use of the water heater, we recommend that you carry out the
hydraulic connection as follows:
Not all appliances labelled on these installation diagrams are supplied by us.
However, the correct installation of the appliance in accordance with the national
regulations in force is under the entire responsibility of the installer.
11
2
SCHEMA DE PRINCIPE AVEC UN CHAUFFE-EAU
DE PRINCIPE AVEC UN CHAUFFE-EAU
10
EN
RECOMMENDATIONS
0.30 m
Figure 1
Capot électrique
Sleeves de raccordement
Connecting sleeves
0.30 m
IMPORTANT NOTE
6
4
2
13
8
9
12
2
4
5
4 3
10
DIAGRAM OF PRINCIPLE WITH ONE WATER HEATER
Electrical cover
1.20m
Key:
1 -
2 -
3 -
4 -
5 -
6 -
7
7 -
8 -
9 -
10 -
2
11 -
1
12 -
13 -
11
Figure 2
Cold water inlet
Stop valve
Water filter
Check valve
Safety valve
Degassing bottle with bleeder
Supply points (with
thermostatic mixers).
Homogenisation pump
(mandatory against
Legionnaire's Disease)
Connection sleeves
For special fitting
Funnel to the drain
Example special fitting
(plate exchanger)
Loop pump
Loop reheater
Document ref.: 428016 03