4.2.3
Storage
NOTICE
!
Risk of regulator damage due to improper
storage.
− Observe storage instructions.
− Avoid long storage times.
− Contact SAMSON in case of different stor-
age conditions or long storage periods.
Fig. 5: Schematic drawing of lifting points on
the regulator
EB 2517 EN
Measures for preparation before installation
Note
We recommend regularly checking the regu-
lator and the prevailing storage conditions
during long storage periods.
Storage instructions
Protect the regulator against external in-
–
fluences (e.g. impact).
Do not damage the corrosion protection
–
(paint, surface coatings). Repair any
damage immediately.
Protect the regulator against moisture
–
and dirt. Store it at a relative humidity of
less than 75 %. In damp spaces, prevent
condensation. If necessary, use a drying
agent or heating.
Make sure that the ambient air is free of
–
acids or other corrosive media.
The permissible storage temperature of
–
standard regulators is –20 to +65 °C (–4
to +149 °F).
Do not place any objects on the
–
regulator.
25