Audio Insert Editing - Sony DHR-1000 Operating Instructions Manual

Editing without LANC cable

Audio insert editing

Tips
• If you do not want to stop
insert editing when the
counter comes to
"0H00M00S," change the
counter display to the time
code.
You can insert both video
and audio by pressing
VIDEO INSERT in step 4.
Notes
Do not change the counter
display during insert
editing. Editing may not
function accurately.
Insert editing cannot be
made on a blank portion of
the tape. When a blank is
detected, the VCR stops
editing.
• It may take up to 7 seconds
for the sound to switch to
the source tape. You cannot
start recording until the
sound switches.
• If you record on the
beginning part of the tape,
or on the part just after the
unrecorded portion, the
first part of recording may
be dropped.
84
Editing
You can replace the original sound with sound from the source tape,
while retaining the original picture.
Before you start editing, set up the system according to the instructions
on pages 77 to 78.
For audio insert editing, use the tape recorded by this VCR. If you want
to edit the one recorded by other VCRs (include other DHR-1000s), first,
you have to dub it to the tape on this VCR, then edit it. If you edit the
tape recorded by the other VCRs, the sound quality may be reduced
and the picture may be noisy.
COUNTER
RESET
COUNTER
SELECT
1
Press COUNTER SELECT so that the tape counter
appears.
2
Locate the end point of the scene to be recorded over.
1 Press · PLAY, then locate the recording end point with the
jog dial or shuttle ring.
2 Press COUNTER RESET.
3
Locate the start point of the scene to be recorded over.
Locate the beginning of the scene to be recorded over with the
jog dial or shuttle ring.
4
Press STEREO 1 INSERT and/or STEREO 2 INSERT as
follows:
When you record from DV input
Press both STEREO 1 INSERT and STEREO 2 INSERT.
You cannot replace stereo 1 track or stereo 2 track only.
When you record from LINE inputs
– To record in 16-bit audio, press both STEREO 1 INSERT and
STEREO 2 INSERT.
– To record in 12-bit audio on the stereo 1 track, press STEREO 1
INSERT.
– To record in 12-bit audio on the stereo 2 track, press STEREO 2
INSERT.
For more information, refer to the chart on the next page.
A few seconds after you press the button the sound switches to
the source tape.
STEREO 1 INSERT
STEREO 2 INSERT
· PLAY
START/PAUSE
Shuttle ring/
Jog dial
P (PAUSE)