Sony DHR-1000 Operating Instructions Manual page 65

Tip
• To connect a monaural
VCR, use LINE-2 IN jack
and connect to the L jack
(white) (leave the red audio
plug unconnected). The
monaural audio from the L
jack will be recorded on
both left and right tracks.
Notes
• If you connect the cables to
both the LINE-2 IN VIDEO
and LINE-2 IN S-VIDEO
jacks , the signal from the
S-VIDEO jack is sent to the
VCR and "S" lights in the
display window. If you
want to use the video signal
from the VIDEO jack, set L2
IN VIDEO in the
ADVANCED OPTIONS
menu to "NORM" (page
54).
• Distorted signals (e.g. when
played back at a speed other
than normal) will not be
recorded properly.
Tips
• Editing is not possible with
a tape that is copyright
protected.
• When you finish editing, set
EDIT switch to "OFF."
Tip
• LANC mode of camcorders
are usually fixed to S.
To a camcorder without DV jack
The LINE-2 IN jacks on the front of the VCR is convenient if you
connect or disconnect a camcorder frequently.
Player
Camcorder
S-video cable
(supplied, when the
other VCR has a
S-VIDEO OUT jack)
Preparation
On the player
• Insert a source tape.
• If the player VCR has an EDIT switch, set it to ON.
• Set LANC mode to "S."
• Turn off the on-screen display.
On the recorder (this VCR)
• Insert a tape.
• Press INPUT SELECT so that the jack to which the player is
connected appears in the display window:
"DV," "L1," or "L2"
• Set LANC mode to "M."
1 Press MENU.
The MENU screen appears on the TV screen.
2
Select ADVANCED OPTIONS by pressing CURSOR (>/.)
buttons and press EXECUTE.
3 Select LANC MODE by pressing CURSOR (>/.) buttons.
4
Select M by pressing CURSOR (?//) buttons.
5 Press EXECUTE.
Recorder
TV
Audio/video cable
(supplied)
LANC cable (supplied)
This VCR
ç: Signal flow
(continued)
65
Editing