Step 2: Setting Up The Remote Commander - Sony DHR-1000 Operating Instructions Manual

Step 2: Setting up
the remote
commander
Notes
• With normal use, the
batteries should last for
approximately three to six
months.
• If you will not use the
remote commander for an
extended period, remove
the batteries to avoid
possible damage from
battery leakage.
• Do not use a new battery
with an old one.
• Do not use different types of
batteries together.
Inserting the batteries
Insert two size AA (R6) batteries by matching the + and – on the
batteries with the diagram inside the battery compartment.
Setting the COMMAND MODE switch
To remotely control the VCR with the commander, set COMMAND
MODE on the remote commander to the same position as that on the
VCR. Usually set to VCR 4. If the other VCR does not have a
COMMAND MODE switch, use the following setting:
VTR 1: For Sony Betamax format VCRs
VTR 2: For Sony 8mm format VCRs
VTR 3: For Sony VHS format VCRs
[TV]/[VTR]
VTR 4: For Sony DV format VCRs
VTR 5 and 6: (reserve)
Using the remote commander
COMMAND
MODE
You can use this remote commander to operate this VCR and a Sony
TV. The POWER, VOL +/–, CH +/–, [TV]/[VTR], channel number,
ENTER, DISPLAY and AUDIO MONITOR buttons on the remote
commander can be used to operate your TV.
To operate
the VCR [VTR] and point at the remote sensor on the VCR
a Sony TV
Set [TV] / [VTR] to
[TV] and point at the remote sensor on the TV
(continued)
9
Getting Started