Sony DHR-1000 Operating Instructions Manual page 71

Notes
• If the remaining time
appears in the display
window of the main unit,
you cannot execute
assemble editing.
Do not select an other input
while assemble editing is
being executed. Editing
may not function correctly.
This VCR may malfunction
if the IN/OUT points are
not separated by more than
two seconds.
If an event you want to
record is marked with a
time code of less than
0:01:00:00, the event will be
edited inaccurately. In this
case, use the manual editing
procedure.
If the time code of the other
VCR is displayed as "–:––:––
:––" during fast-forward or
rewind, assemble edit may
not function.
You cannot press PLAYER
while this VCR is in
playback mode.
Do not press MARK while
the other VCR is in stop
mode. Assemble editing
may not function correctly.
If you record over a
previous recording, the end
of the new recording will
not continue on to the
original recording smoothly.
• If you record on the
beginning part of the tape,
or on the part just after an
unrecorded portion, the
first part of the recording
may be dropped.
• When you record on a new
or fully rewound tape, do a
trial recording for about 15
seconds, then start the
actual recording. If you
start the actual recording
from the beginning of the
tape, the first part may not
be recorded when you play
back the tape on another
VCR.
Tips
To prevent tape damage, the
tape automatically stops if
recording pause continues
for 5 minutes.
To record to the end after
the last event, leave the
OUT point of the last event
unspecified.
1
If the other VCR has a time code
function, set it to the time code
display.
If not, set it to tape counter.
2
Press ASSEMBLE.
The indicator lights up.
3
Designate the IN point of the first
event.
1 Press PLAYER and start playing the
tape.
2 Locate the IN point with the jog dial
or shuttle ring.
3 Press MARK.
The IN point is stored.
4
Designate the OUT point.
1 Locate the OUT point with the jog
dial or shuttle ring.
2 Press MARK.
The OUT point of the first event is
stored.
The total recording time is displayed.
A few seconds later, "IN" flashes and
you can designate the IN/OUT points
for the next event.
5
To designate other events, repeat
steps 3 and 4.
You can designate up to 10 events.
To check/change events
Press EVENT BACK or EVENT FWD to
display each event in turn, and change
the IN/OUT points according to the
procedure in step 3 and 4 if required.
6
Locate the point you want to
start recording on this VCR.
1 Press RECORDER.
2 Press ( (PLAY), then search for the
recording start point with the jog dial
or shuttle ring.
3 Press START/PAUSE so that this
VCR is set to recording pause.
(continued)
71
Editing