Sony RM-VL1000 Operating Instructions Manual page 57

4
Press the Label Select
button of the program
number of which the
contents you want to
change.
SET
With a beep sound, the
contents of the selected
program (in this case, PROG1)
are copied to the program
number displayed on the top of
the display (in this case,
PROG4).
5
Select "SETUP" by pressing
the Label Select button.
SET
The display turns to the setting
up mode of the timer.
SET
6
Press the Label Select
button of the label of which
contents you want to
change.
Day: See Step 6 on page 52.
Time: See Step 7 on page 53.
MACRO: The display appears
as below.
SET
7
Select "OK?" by pressing
the Label Select button.
With a beep sound, the Timer
Macro setting is cleared, and
the Commander enters the
Timer Macro setting mode
(Step 10 on page 54).
If you select "NG?"
The display returns to the setting
up mode.
Note
You cannot change the Timer Macro
setting partially. If you want to
change the program without
clearing the frequently used
procedure, use the System Control
function (page 34). For example, if
Steps A to D are frequently used
when you want to program Steps
A, B, C, D and E, program Steps A
to D using the system macro. Then
program Step E in the Timer Macro,
combining it with that System
Macro.
Continued
57