Receiving The Data - Sony RM-AV3000 Operating Instructions (primary manual) Operating Instructions Manual

Transferring Data between
Commanders (continued)

Receiving the data

This Commander can receive the data of
another Sony RM-AV3000.
To receive all the data from
another remote commander
1
Follow Steps 1 to 5 on page 53.
2
Press the x key.
X : Transfer data
x : Receive data
3
Press the ALL key.
ALL
ALL:
COMPO: Data of a Component
56
All data of the Commander
Select button or a Label key
"ALL x" appears on the Mode
Display key, and "ALL" appears on
the left Label key.
4
Press the ENTER key.
During receiving the data,
"cccc cccc" flashes.
When all the data has been
successfully transferred, "ALL"
appears on the right Label key.
Notes
• If the Commander is not ready for
receiving the data, press the CLEAR key,
then press the RETURN key to clear all
the learned signals.
• If "NG" appears during data transfer, go
back to Step 3 and continue the operation
or press COMMANDER OFF to stop the
operation. If you continue the operation,
you have to set the sending Commander
again to send data.