Concept2 BikeERG Product Manual page 6

Maintenance
RECOMMENDED MAINTENANCE
SCHEDULE
After first five Hours of Use
• Check all fasteners for tightness.
Daily
• Clean saddle, handlebars,
step pad and flywheel cover
with a cloth and cleaner
after use.
• Do not use bleach or coarse
abrasives.
Every 250 Hours of Use
• Check that the crank arms are tight on the crank
axle. Tighten the clamp screws if needed using the
L-key supplied with the BikeErg. See illustration.
• Check all fasteners for tightness.
• Check for dust inside flywheel with a flashlight.
Vacuum if needed. See illustrations at right.
Verify calibration after cleaning. On the PM go to
Main Menu > More Options > Utilities > Calibration.
As Needed
Check the fit of the seat post.
The seat post should move
up and down with only light
pressure applied. The seat post
fit can be adjusted using a ½"
wrench (not included) where
shown. Do not overtighten.
WARRANTY INFORMATION
Concept2 BikeErgs are backed by a limited 2 year and
5 year warranty. For complete warranty information in
the US and Canada, visit concept2.com/warranty.
For warranty information outside the US and Canada,
contact the authorized Concept2 dealer in your
territory. A list of authorized Concept2 dealers can be
found at concept2.com/international. If you do not find
a local dealer in your territory visit concept2.com or
email info@concept2.com.
WARNING!
only if it is examined regularly for damage and wear. Replace
defective or worn components immediately to ensure safety and
performance or keep machine out of use until repair.
FLYWHEEL OPENING AND CLEANING
1.
3.
DETAIL B
SCALE 1 : 4
5.
7.
The safety level of the machine can be maintained
2.
Loosen screws.
4.
B
6.
ENGLISH
5