Advertisement
CONTENTS
1. Warning .......................................................................................
2. Assembly .....................................................................................
3. Operation .....................................................................................
4. Maintenance ................................................................................
5. Troubleshooting ................. ......................................................
6. Warranty .............................. ......................................................
IMPORTANT SAFETY INSTRUCTIONS
When using this electrical equipment, basic safety precautions should always be
READ AND FOLLOW ALL INSTRUCTIONS.
WARNING - To reduce the risk of injury, do not permit children to use this product
unless they are closely supervised at all times.
A wire connector is provided on this unit to connect a minimum 8 AWG (8.37 mm
solid copper conductor between this unit and any metal equipment, metal enclosures
of electrical equipment, metal water pipe, or conduit within 5 feet (1.5 m) of the unit.
DANGER - Risk of injury.
a) Replace damaged cord immediately.
b) Do not bury cord.
c) Connect to a grounded, grounding type receptacle only.
WARNING - This product is provided with a ground-fault circuit-interrupter integrated
with the power plug at the end of the cord. The GFCI must be tested before each
use. With the product operating, push the test button on the GFCI and the product
should not operate. Push the reset button on the GFCI and the product should now
operate normally. When the product fails to operate in this manner, there is a ground
current flowing indicating the possibility of an electrical shock. Disconnect the power
until the fault has been identified and corrected.
DANGER - Risk of Accidental Drowning. Extreme caution must be exercised to
prevent unauthorized access by children. To avoid accidents, ensure that children
cannot use this spa unless they are supervised at all times.
DANGER - Risk of Injury. The suction fittings in this spa are sized to match the
specific water flow created by the pump. Should the need arise to replace the suction
fittings or the pump, be sure that the flow rates are compatible. Never operate spa if
the suction fittings are broken or missing. Never replace a suction fitting with one
rated less than the flow rate marked on the original suction fitting.
DANGER - Risk of Electric Shock. Install at least 5 feet (1.5 m) from all metal
surfaces. As an alternative, a spa may be installed within 5 feet of metal surfaces if
each metal surface is permanently connected by a minimum 8 AWG (8.37 mm
copper conductor to the wire connector on the terminal box that is provided for this
DANGER - Risk of Electric Shock. Do not permit any electric appliance, such as a
light, telephone, radio, or television, within 5 feet (1.5 m) of a spa.
WARNING - To reduce the risk of injury:
WARNING
followed, including the following:
2
P2
P6
P8
P8
P11
P12
)
2
) solid
2
S-S-005131
- Quick Links:
- Assembly
- Operation
- Maintenance
- Troubleshooting
Hide quick links:
Advertisement
Need help?
Do you have a question about the SaluSpa and is the answer not in the manual?
Questions and answers
What kind of power does it require
The power requirement for the Bestway SaluSpa is 110-120V AC, 12A at 68ºF (20ºC).
This answer is automatically generated
sides of the spa are getting quite slimy after being on and minimal use..is any way chen=micals best to stop this filtering is good changes when discolored
To prevent slimy sides in a Bestway SaluSpa, you can use chemical tablets or chemical liquid. When using chemical tablets, do not use granulated tablets or throw them directly into the water, as they can damage the material and discolor the PVC. When using chemical liquid, add it in small doses at the center of the pool to avoid direct contact with the spa surface. It is also important to test and maintain proper water chemistry levels:
- pH: 7.4-7.6
- Total Alkalinity: 80-120 ppm
- Free Chlorine: 2-4 ppm
Always remove the chemical dispenser when the spa is in use and test the water chemistry before using the spa.
This answer is automatically generated
How do I inflate the spa
To inflate the Bestway SaluSpa Miami Inflatable Hot Tub, follow these steps:
1. Ensure the pump is unplugged before starting.
2. Attach the provided inflation hose to the pump.
3. Connect the other end of the hose to the spa's inflation valve.
4. Plug in the pump and turn it on to begin inflating.
5. Allow the spa to inflate for about 3 to 6 minutes until fully expanded.
6. Turn off the pump and disconnect the hose.
7. Secure the inflation valve to prevent air from escaping.
Check the inflation level periodically, as temperature changes can affect pressure.
This answer is automatically generated
We have Hermosa Saluspa Inflatable Hot Tub - Does the floor inflate?
how do i deflate the saluspa hermosa 7 model?
To deflate the Bestway SaluSpa Hermosa 7 model, follow these steps:
1. Unscrew the Deflation Valve – Locate the valve used for inflation and unscrew it to allow air to start escaping.
2. Attach the Inflation Hose – Connect one end of the inflation hose to the deflation valve.
3. Connect to the Pump Unit – Attach the other end of the hose to the pump unit.
4. Turn on the Pump Unit – Power on the pump.
5. Press the Jet Button – Activate the jet function to rapidly deflate the spa.
Ensure the pump is unplugged before maintenance for safety.
This answer is automatically generated
@Mr. Anderson
which is the deflation valve? the pump is inside the spa walls
to clarify, i know where the deflation valve is. when i connect to the pump, it seems to add air back to the unit
how do i deflate Saluspa horizon 7 model
can I use the underwater patch for the exterior as it has an air leak
Yes, you can use the provided PVC repair patch for an exterior air leak. Clean and dry the area, cut the patch to size, apply glue (not included), press it firmly over the leak, and wait 30 minutes before inflating.
This answer is automatically generated
What type of pump do I use? I have an error code E02 flashing We were given the hot tub and it did not come with pump and inflation tube so I need to know what to buy please?
It does not stay inflated, where should i be checking for leaks???
Where can I find someone local to help me! Spa turns off when I turn heat on