Printing Summary Statistics For One Or More Patients; Sample Printout: Summary Statistics - GE TruSat User Manual

TruSat User's Guide

Printing summary statistics for one or more patients

Sample printout: Summary statistics

A–4
You can print a statistical summary of each record stored in the monitor. Trends for
the most recent patient are printed first.
1. After monitoring one or more patients, unplug the sensor from the monitor.
NOTE: Press the Alarm Silence button to silence alarms.
2. Connect the printer.
3. To start printing, use the ComWheel to move the pointer to the print
symbol, then press the ComWheel. Repeat to stop printing.
The print symbol is displayed during printing.
Important: The monitor calculates the data before printing begins. When printing
a long record for a single patient, printing will be delayed approximately
1 minute for every 24 hours of data. The monitor may appear to be inactive,
however, printing will begin when the calculation is completed.
NOTE: Printing continues until all trends stored in memory for previous patients are
printed or until printing is stopped.
Trends, most recent patient
General information:
• Patient number and lines for
adding information.
• Start time, start date, and duration,
based on monitor clock settings.
• Total time readings were valid.
• Total time readings were not
collected because, for example, the
sensor was off the patient.
Statistical summary:
• Lowest and average SpO
and their standard deviation.
• Percentage of time SpO
were within specific ranges.
• Maximum number of minutes SpO
was continuously below 90%.
• Maximum number of minutes SpO
was continuously at or below 85%.
readings
2
readings
2
2
2