Table of Contents
Advertisement
Speakers
Description
Speaker Kit (includes left and right speakers and cables)
Before removing the speakers, follow these steps:
1.
Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2.
Disconnect the power from the slate by unplugging the power cord from the slate.
3.
Disconnect all external devices from the slate.
4.
Disconnect the slate from the keyboard/base.
5.
Remove the display panel assembly (see
Remove the speakers:
1.
Disconnect the left and right speaker cables (1) from the speaker connectors on the system board.
2.
Release the right speaker cable from the routing clips (2) built into the battery.
3.
Remove the four Phillips PM2.0×3.8 screws (3) that secure the speakers to the display back cover.
4.
Remove the speakers (4).
Reverse this procedure to install the speakers.
Display panel assembly on page
Component replacement procedures
Spare part number
841570-001
22).
33
Advertisement
Table of Contents
