e.
Solid-state drive (see
f.
Connector board (see
g.
System board (see
h.
Battery (see
Remove the cables:
1.
Detach the power button board cable (1) from the display back cover. (The power button board cable
is attached to the display back cover with double-sided adhesive at the locations shown in
the following illustration.)
2.
Detach the volume control board cable (2) from the display back cover. (The volume control board cable
is attached to the display back cover with double-sided adhesive at the locations shown in
the following illustration.)
3.
Detach the USB port cable (3) from the display back cover. (The USB port cable is attached to the display
back cover with double-sided adhesive at the locations shown in the following illustration.)
4.
Detach the audio jack cable (4) from the display back cover. (The audio jack cable is attached to
the display back cover with double-sided adhesive at the locations shown in the following illustration.)
Reverse this procedure to install the cables.
40
Chapter 5 Slate removal and replacement procedures
Solid-state drive on page
Connector board on page
System board on page
Battery on page
38)
32, select models only)
34)
36)