Table of Contents
Advertisement
TouchPad board
Description
TouchPad board
TouchPad board cable (includes double-sided adhesive)
TouchPad board bracket (included with the TouchPad board spare part kit, spare part number 841561-001)
Before removing the TouchPad board, follow these steps:
1.
Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2.
Disconnect the power from the slate by unplugging the power cord from the slate.
3.
Disconnect all external devices from the slate.
4.
Remove the bottom cover (see
Remove the TouchPad board:
1.
Release the ZIF connector (1) to which the TouchPad board cable is attached, and then disconnect
the TouchPad board cable from the docking board.
2.
Detach the TouchPad board cable (2) from the keyboard/top cover. (The TouchPad board cable is
attached to the keyboard/top cover with double-sided adhesive.)
3.
Release the ZIF connector (3) to which the keyboard cable is attached, and then disconnect the keyboard
cable from the docking board.
4.
Detach the keyboard cable (4) from the keyboard/top cover. (The keyboard cable is attached to
the keyboard/top cover with double-sided adhesive.)
5.
Remove the three Phillips PM2.0×2.5 screws (5) that secure the TouchPad board bracket to
the keyboard/top cover.
Bottom cover on page
44).
Keyboard/base component replacement procedures
Spare part number
841561-001
841552-001
47
Advertisement
Table of Contents
