Advertisement
4. Connect Power
Plug the AC power cord into the socket on the rear of the
1
switch.
Connect the other end of the power cord to an AC power
2
source. Verify that the external AC power requirements
for the switch can be met as listed below:
SC30010: 100-240 VAC, 50/60 Hz, 1 A
SC30020: 100-240 VAC, 50-60 Hz, 5.8 A
SC30030: 100-240 VAC, 50-60 Hz, 3.2 A
SC30040: 100-240 VAC, 50-60 Hz, 0.5 A
SC30050: 100-240 VAC, 50-60 Hz, 2.1 A
SC30060: 100-240 VAC, 50-60 Hz, 0.5 A
Warning: For the SC30050, the bottom of the
enclosure is a hot surface. Do not touch!
Note: For International use, you may need to change the
AC line cord. You must use a line cord set that has been
approved for the socket type in your country.
5. Verify Switch Operation
Verify basic switch operation by checking the system
1
LEDs.
When operating normally, the Power and Diag LEDs
should be on green.
www.signamax.com
1
6. Connect to the Web User Interface
Connect a PC to the switch through one of the RJ-45
1
ports.
The switch has a default management IP address of
2
192.168.2.10 and a subnet mask of 255.255.255.0. You
must set your PC IP address to be on the same subnet
as the switch (that is, the PC and switch addresses must
both start with 192.168.2.x).
Log in to the web interface or CLI using the default
3
settings: username "admin" and password "admin."
Note: For further information on switch configuration,
refer to the Web Management Guide and CLI Reference
Guide.
7. Connect Network Cables
1
For RJ-45 ports, connect 100-ohm Category 5, 5e or
1
better twisted-pair cable.
For the SFP/SFP+ slots, first install SFP/SFP+
2
transceivers and then connect fiber optic cabling to the
transceiver ports. The following transceivers are
supported:
1000BASE-SX (065-79SXMG)
◆
1000BASE-LX (065-79LXMG)
◆
1000BASE-ZX (065-79ZXMG)
◆
1000BASE-LHX (065-79LXEDMG)
◆
As connections are made, check the port status LEDs to
3
be sure the links are valid. Press the Mode button to
change from Ethernet to PoE status:
On/Blinking Green — Port has a valid link.
◆
Blinking indicates network activity.
On Amber — Port is supplying PoE power.
◆
– 2 –
Quick Start Guide
2
Advertisement
