Panasonic AG-DVX100BP Service Manual page 53

2. Connect the 2 pcs. of 30 pin flat cables (VFK1317) between P101/P102 on the Measuring Board (VFK1308P),
and 2 connectors on the EVR Connector Board (VFK1309A). Make sure that the contact surface of 2 pcs. of 30
pin Flat Cables are inner side and direction of the EVR Connector Board is as shown in Figure. Then connect
the Connection Adapter (VFK1763).
Connect VFK1763 with VFK1309A as
shown in picture.
The unit will not work if the connector
is attached backwards.
3. Connect the Extension Cable (VFK1982) to Connection Adapter (VFK1763).
Connect VFK1982 with VFK1763 as
shown in picture.
The unit will not work if the connector
is attached backwards.
4. Connect the Extension Cable (VFK1982) to EVR connector in Unit. Then make sure that the direction of the
VFK1982 is correct as shown in Figure.
When the VFK1982 is connected to EVR connector, be careful of the direction of connector on VFK1982.
Please follow as shown in the figure.
EVR CONNECTOR
Part side
VFK1763
Connect the
VFK1763
MECH-3
VFK1309A
30 pin Flat Cable
VFK1308P
VFK1982
VFK1763
VFK1309A