Note When Inserting Flexible Cable; Type Of Screws - Panasonic AG-DVX100BP Service Manual

2. Note when inserting Flexible
Cable
The flexible cables, have two sets of contacts on each
cable, see the figure below. When inserting these
cables into the connector, make sure that the cables
are fully inserted, if not they may damage the
connector.
TWO CONTACT
POINTS
P51 on BACK CONNECT C.B.A.
P4670 on R_SIDE C.B.A.
P1004 and P1006 on CAMERA C.B.A.
P3001 on VTR C.B.A.
P1001 on LED LEV C.B.A.(LCD UNIT)
CCD ←→ P1004
LENS ←→ P1006
P52 (BACK CONNECT C.B.A.) ←→ P4604 (R_SIDE
C.B.A.)
P3001 (VTR C.B.A.) ←→ P4401 (SIDE_JACK C.B.A.)
& P4000(EXT MIC CH1 C.B.A.) : one contact point
LCD Panel ←→ P1001
When P1004 flexible cable is not making correct
contact, the camera's picture will not be seen.
When P1006 flexible cable is not making correct
contact, the LENS will not operate.
When P51 or P4670 flexible cable is not making
correct contact, the VTR will not operate.
If any of the above symptoms occur after you
assemble the camera recorder, please check the
indicated connector.
FLEXIBLE CABLE
(REAR SIDE)

3. Type of Screws

As for this procedure, a screw is described by the
alphabet. The specified screw, refer to the table below
about any type. When constructive, be careful not to
mistake to put a screw.
TYPE
A
BLACK
B
SILVER
C
D
E
SILVER
F
DIS-2
Figure Apply to screw
4mm
A, B, C, D, E, F, G,
K, N, O, P, W, X, Y
4mm
H, I, L, M, Q, T, U, Z
4mm
SILVER
6mm
BLACK
5mm
5mm
SILVER
J
R
S
V