Miele PWM 908 Operating And Installation Instructions page 11


If the appliance is hard wired, an on-site all pole circuit breaker
must always be accessible to disconnect the washing machine from
the mains.

This washing machine is supplied with a special lamp to cope
with particular conditions (e.g. temperature, moisture, chemical res-
istance, abrasion resistance and vibration). This special lamp must
only be used for the purpose it is intended for. It is not suitable for
room lighting. Replacement lamps may only be fitted by a Miele au-
thorised person or the Miele Service Department.

Reliable and safe operation of this washing machine can only be
assured if it has been correctly connected to the mains electricity
supply.
Correct use

The maximum dry laundry weight is 8.0 kg. The maximum recom-
mended loads for individual programmes are given in the Programme
chart.

Do not install your washing machine in a room where temperat-
ures below freezing may occur. Frozen hoses may burst or split. The
reliability of the electronic control unit may be impaired at temperat-
ures below freezing point.

Before using the machine for the first time, check that the transit
bars at the rear of the washing machine have been removed (see "In-
stallation – Removing transit bars"). During spinning, transit bars
which are still in place may result in damage to both the machine
and adjacent furniture or appliances.

Close the stopcock if the machine is to be left for any length of
time (e.g. while on holiday), especially if there is no floor drain (gully)
in the immediate vicinity.
Warning and safety instructions
11