Chapter 6 Installation And Wiring; Installation And Removal Of Sd Memory Card - Mitsubishi Electric MELSEC iQ-R RD78G4 User Manual

6
INSTALLATION AND WIRING
6.1

Installation and Removal of SD Memory Card

This section describes the methods for installation of an SD memory card to the Motion module, and removal.
Installation of SD memory card
• When installing an SD memory card to the Motion module, take note of the SD memory card position, and install using the
following procedure.
1.
With the notch facing downwards, insert the SD memory card straight into the slot. After inserting check the SD memory
card is inserted all the way in. If the SD memory card is not inserted properly, insufficient contact may cause an operation
failure.
2.
The CARD READY LED flickers until the SD memory card can be used. When the CARD READY LED is ON, the SD
memory card can be used.
3.
If the CARD READY LED does not turn on after installing an SD memory card, check that
System.Cd.Storage_sdcForcedDisable and System.Md.Storage_sdcForcedDisabled are FALSE.
CARD READY LED
SD memory card
RD78G
• Installation of an SD memory card is registered with the event history (type: operation).
When installing an SD memory card, the operation of SD memory card access control switch is not required.
CARD READY LED
SD memory card
RD78GH
6 INSTALLATION AND WIRING
6.1 Installation and Removal of SD Memory Card
6
37