Task Mode Device Selection And Configuration - Applied Systems Engineering ASE2000 User Manual

4.4.2. Task Mode Device Selection and Configuration
In Task Mode, protocol selection and configuration is accomplished by selecting a device where
protocol is a property of the device selected. Device selection is performed in one of three ways:
• Default device on start-up – If the default Operational Mode on start-up is Task Mode and
there was an "active" device during the previous execution, the last active device will be the
default active device on start-up.
• Select previously defined device – To select a device that is different than the current active
device, select from the list of displayed devices in the "Task" window. If the required device
has been previously defined but does not appear in the list of displayed devices, select "Edit
> Configure RTUs..." and check the "Display" check box for the desired device then select
"Finish". The device should now be displayed in the devices area of the Task window and can
be selected as the active device by clicking on the line containing the device.
ASE2000 V2 Communication Test Set User Manual 18