Advertisement
DO NOT USE THE SANDER "
WITHOUT A PROPER ABRASIVE PAD INSTALLED (to prevent severe damage to the work).
THE REPLACEMENT OF GRINDING DISK STUCK
The output shaft is inserted into the adhesive disc center with six angle wrench clockwise rotation an-
gle in the six-hex, and at the same time, the hands hold the adhesive disc grinding, grinding disc can
be remove adhesive
SPEED ADUSTMENT:
The grinding of the grinding disk rotation speed can be adjusted according to different conditions and
grinding quality requirements.
The Drywall Sander is equipped with a variable speed control. The speed is adjusted by turning the
control
knob. The control knob is numbered "min" through "max" with "min" being the slowest speed
(Approximately 1000 RPM) and "max" being the fastest speed {approximately 2100 RPM).
Use the higher speed settings for fast stock removal. Use the lower speed selling to reduce removal
rate for
more precise control
© by WilTec Wildanger Technik GmbH
Seite 20
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Advertisement
