Software; Grundfos Bms Hs; Grundfos Bms Hp - Grundfos BMS Series Service Instructions Manual

www.motralec.com / service-commercial@motralec.com / 01.39.97.65.10

6. Software

In this section you find information about how to set parameters
via PC.

6.1 Grundfos BMS hs

Find the newest setting software at the Leroy-Somer website:
http://www.emersonindustrial.com.
6.1.1 POWERDRIVE FX, MD and MD2
With MDX-SOFT, setting parameters and supervising the
POWERDRIVE from a PC is very user-friendly.
Numerous functions are available:
• quick commissioning with the simplified menu
• file saving
• help file
• comparison of two files or one file with the factory settings
• supervision in table or progress bar form
• diagnostics
• representation of parameters in a table.
You can download the MDX-SOFT software from the Internet at
the following address: http://www.leroy-somer.com/fr/
telechargements/logiciels/
To connect the PC to the POWERDRIVE, use an
"MDXUSBIsolator" isolated USB kit.
Procedure:
1. Connect the PC (USB-A) to the POWERDRIVE controller
(USB-B) via the USB connection. The communication is ready
when you can read the "USB" on the display of the red
indicator light
USB-A
2. Start up the MDX commissioning software. Use the help menu
displayed as a "?". Here you find a guide on how to use the
program.
3. Select an action
– "Supervision only"
– "Download drive settings"
– "Create new file"
– "Open existing file"
– "Data logger".
4. Select the needed action menu
– "Simplified menu"
– "Advanced menu"
– "General setup"
– "Supervision menu"
– "Monitoring"
– "Charts".
USB-B
5. Save the changes and exit the program.
6. Remove the USB connection.

6.2 Grundfos BMS hp

Grundfos BMS hp is setup by factory. The settings are default
settings for a Grundfos BMSX application.
You can change the user specific parameters (duty point etc.) via
either:
• Grundfos R100
• Grundfos PC tool link
• Grundfos GO.
For further information, see the installation and operating
instructions for Grundfos MGE.
13