Table of Contents
Advertisement
www.motralec.com / service-commercial@motralec.com / 01.39.97.65.10
5.8.3 Positioning the inlet pipe
To change the position of the pipe, follow this procedure.
Step Description
Remove the M10
bolts.
1
Loosen the M12
bolts.
Mark up the pump
2
sleeve and union nut.
Turn the inlet pipe to
the needed position,
3
and make sure the
union nut follows.
4
Check the marking.
Fit all bolts again.
5
Tighten all bolts to 33
Nm.
Fasten the support
6
foot to the
foundation.
12
Picture
Advertisement
Table of Contents
