Table 3. Jumper Information - VersaLogic Tetra VL-EPC-2700 Hardware Reference Manual

Configuration and Setup

Table 3. Jumper Information

EPC-2700
Reference
Designator
V1
V2
Tetra (VL-EPC-2700) User's Guide
EPC-2700
Signal Name
BOOT_MODE0
USB_OTG_ID
Control/Description
BOOT_MODE0 setting, to allow use
of USB OTG Device communications
using the NXP i.MX6 Serial
Downloader method. When this
jumper is installed V2 should not be
installed! Normal eFuse selected
boot via SPI NOR Flash U-Boot and
microSD card Yocto Linux when the
jumper is removed.
Install jumper to set USB_OTG port to
host mode. No jumper sets port to
Device Mode
15