Table of Contents
Advertisement
SECO-LARM Electric Door Strike with Vertical Adjustment
Installing the Crimp Connectors:
Crimp connectors are provided to make wiring
connections easier and more reliable. To install
the connectors:
1. Insert the wires into the connector
(see "12/24 VDC Wiring Diagram," page 6).
2. Use a crimping tool or pliers to evenly press
down on the head of the connector.
12/24 VDC Wiring Diagram*:
For 12VDC Operation*:
1. Use the included electrical connector
marked 12VDC and connect its
red/black wires to the positive and
negative terminals of the control device.
For 24VDC Operation*:
1. Use the included electrical connector
marked 24VDC and connect its
white/black wires to the positive and
negative terminals of the control
device.
Diagrams are for illustrative purposes only. Polarity of wires is not important.
*
Selecting Fail-Secure or Fail-Safe:
1. Remove the locking screw and loosen the sliding screw.
2. Slide the sliding screw to the desired setting. Replace the locking screw and retighten both
screws.
Fail Safe:
SECO-LARM
FAIL-SAFE
FAIL-SECURE
6
®
Sliding
screw
Crimp
Connector
SECO-LARM
FAIL-SAFE
Locking
FAIL-SECURE
screw
SECO-LARM U.S.A., Inc.
Black Wire
Red Wire
White Wire
12V
24V
Factory default: Fail-safe
Fail Secure:
®
Advertisement
Table of Contents
