Adapter Cards; Selection; Installation; Custom Adapter Cards - Cablescan 128/PC Instruction Manual

Model 128/PC Instruction Manual

SELECTION

Cable adapters normally are employed in pairs, one for the left side of the interface fixture, and
one for the right side. Select each adapter to match its respective end of the cable being tested.
Cablescan adapters are described at the end of this manual. A list of adapter cards is provided
later in the section.
Adjustable
Hold-down Bar
Knurled
Set Screw
A-01/Pin #1 (Top)

INSTALLATION

To install the adapters proceed as follows:
1. Open ZIF connector levers, slide adapter cards in from the top and all the way laterally
into their respective connectors. Each adapter card is designed to fit on either the right or
left side.
2. Loosen knurled set screw to slide adjustable hold-down bar in or out to accommodate
width of adapter card.
3. With adapter cards properly in place, close ZIF connector levers.
4. Run Self Test before a cable is installed to make sure no shorts are present due to damage
or improperly installed adapters.

CUSTOM ADAPTER CARDS

ADAPTER CARDS

A SIDE
Remove/ Adapters
Insert
ZIF Levers
B SIDE
Remove/
Cards Insert
ZIF Levers
B-01/Pin #65 (Top
Page 37
Adjustable
Hold-down Bar
Knurled
Set Screw