Menu-Selected Modes And Functions; Save Program - Cablescan 128/PC Instruction Manual

Model 128/PC Instruction Manual

MENU-SELECTED MODES AND FUNCTIONS

The nine menu-selected modes and functions are as follows:

Save Program *

Load Program
Delete Program *
Clear Memory *
These menu-selectable modes and functions are accessed through the MENU RUN key and the
Up and Down arrow keys. To select one of the menu modes or functions, use the following
standard procedure:
1. Press Up or Down arrow to step through the menu until the desired function or mode is
displayed.
2. Insert the Enable plug if the mode, in the above list, ends with an asterisk (*).
3. Press MENU RUN to initiate the function or mode.
MODEL 128
Save Program
The Save Program function is used to copy the program from the Test Memory to the Program
Memory. A complete Save Program procedure is provided below. Once familiarized, however,
the user may refer to Figure 8. To select and use the Save Program function, proceed as follows:
1. Insert Enable jack in the rear panel. (See Figure 2.)
2. Press the Up or Down arrow to step through the menu to display Save Program.
3. Press MENU RUN to initiate the save function. If there is sufficient Program Memory
for the program, the display will query:
* Requires the Enable jack to operate.
LEARN
Are You Sure?
Self Test
Loop Test
Set Baud Rate *
Print Wire List
Print User List
ERROR
SEARCH
LIST
MENU
RUN
Menu-select Keys (3)
Page 19
TEST RESET