Print Commands; Program Commands - Cablescan 128/PC Instruction Manual

Page 28 Model 128/PC Instruction Manual
Search - SB
Same as SEARCH key on the front panel. Displays the test points or user label assignments on
the monitor as points are probed.

PRINT COMMANDS

The following list contains all print-related commands. The printout will appear on the monitor
during printing since the PC uses the same port as the printer. Output will pause after displaying
20 lines. If there are additional lines, MORE will display at the end of each full screen.
Pressing ENTER will continue the output. At the system prompt, enter the two-letter command,
followed by an ENTER.
Print Wire List - PW
Same as Print Wire List selected from the front panel Menu.
Print Error List - PE
Same as ERROR LIST key on the front panel.
Print User Labels List - PU
Same as Print User List selected from Menu.

PROGRAM COMMANDS

The following list contains commands related to loading, saving, and deleting wire list programs.
These are two-letter commands, which are executed by pressing the two letter keys followed
with an ENTER.
Clear Memory - CM
This command is the same as Clear Memory selected from the Menu. When the prompt Are you
sure? is displayed, pressing the letter Y will erase the program and User Labels in Test Memory.
If you decide not to clear memory, press the letter N.
Delete Program - DI
This command is the same as Delete Program selected from the Menu. Delete Program is used
to erase a wire list program in the Program Memory. When the DI command is typed, followed
by an ENTER, the signature of one of the programs in memory is displayed. Pressing the letter
D advances down through the list displaying the next program signature. Pressing the letter U
displays the signature in the reverse order. When the signature of the program to be deletes is
displayed, press ENTER. The prompt prompt Are you sure? is then displayed. Pressing the
letter Y will erase the program. If you decide not to erase the program, press the letter N.