Zone Programming; What Is An Expansion Input - Paradox Spectra 1725 Programming Manual

Hide thumbs

Table Of Contents

Table of Contents

When programming zones please note that the Spectra control panels' zone assignment is dependent on where

the detection devices in the system are connected (see Table 2 below).

Device connected to

which input?

Control Panel Input 1 =

Control Panel Input 2 =

Control Panel Input 3 =

Control Panel Input 4 =

Control Panel Input 5 =

Keypad Zone 1 =

Keypad Zone 2 =

Expansion Input 1 =

Expansion Input 2 =

Expansion Input 3 =

Expansion Input 4 =

Expansion Input 5 =

Expansion Input 6 =

Expansion Input 7 =

Expansion Input 8 =

WHAT IS AN EXPANSION INPUT?

There are a total of eight expansion inputs available. Each hardwired input on a Zone Expansion Module or wireless

transmitter used by the Liberator

be used in any combination. For example, you can assign four wireless transmitters as well as 4 hardwire inputs to the

expansion inputs. Regardless of how many expansion modules are being used, the control panel cannot support more

than eight expansion inputs. The expansion module inputs are assigned as follows:

SPC-319 Liberator Wireless Bus Module

Wireless transmitters assigned to sections [601] to [608] of the control panel represent expansion inputs 1 to 8 respectively.

Refer to Wireless Transmitter Assignment on page 22.

SPC-ZX4 and SPC-ZX8 Zone Expansion Module

Detection devices connected to input terminals Z1 to Z4 of the SPC-ZX4 module or Z1 to Z8 of the SPC-ZX8 module,

represent expansion inputs 1 to 8 respectively. Please note that the module's inputs must be enabled in section [651] of the

control panel. Refer to Zone Assignment on page 25.

Do not assign devices from different modules to the same expansion input. For example, do not assign a

wireless transmitter to section [601], then connect a detection device to input Z1 of the SPC-ZX8 and enable

option [1] in section [651].

Programming Guide