Sullair LS-32 Operator's Manual And Parts List page 31

essary to check the direction of the motor rotation.
With the control system in MANUAL mode, press
the and pads in succession to bump start
the compressor. When looking at the motor from the
end opposite the compressor unit, the shaft should
be turning clockwise on all gear driven models, and
counterclockwise on direct drive models.
motor shaft is not turning in the proper direction,
disconnect the power to the starter and exchange
any two of the three power input leads, then re-
check rotation. A "Direction of Rotation" decal is
located on the coupling guard between the motor
and compressor to show proper motor/compressor
rotation.
If the
Section 4
INSTALLATION
25