Figure 50: Screen For Managing Templates; Figure 51: Warning Message At Start Of Creating New Template - Peleman Flat Bed Foil Printer User Manual

Flat Bed Foil Printer User Guide
New templates may be created by the user by selecting the Create New Template option.
Section 5.8.5.1 may be referred to for further information about the creation of new
templates. Similarly, the templates may be imported or exported. Section 5.8.5.2 may be
referred to for available options regarding importing and exporting templates.

Figure 50: Screen for Managing Templates

5.8.5.1 Create New Template
Users can create new templates based on custom dimensions. Most common PELEMAN
products are included in the Flat Bed Foil Printer PC Tool by their product names as
templates. If a PELEMAN product cannot be found, please check for updates or create a
new template. Go to section 5.8.3 to read more about updating the Flat Bed Foil Printer PC
Tool.
New templates must be based on a printable object. The measurements to be taken are
described in this section.
When Create new template tab is selected, a warning message will appear, as shown in
figure 51, reminding the user of the severity of incorrect values.

Figure 51: Warning Message at Start of Creating New Template

Only click the Continue button if you are sure about the values you are about to type in.
Failure to do so can cause severe damage to the machine.
The maximum dimensions of the template are 430x304 mm. The actual object, however,
can be larger. However, the actual printed area cannot be larger than 440x280 mm.
Select the type of cover for the new template and then click on Next.
53
Peleman Industries