How To Insert The Foil; Figure 10: Connecting The Coils - Peleman Flat Bed Foil Printer User Manual

Flat Bed Foil Printer User Guide
*
**
***
****
*****
N/A
V
/

4.3 How To Insert The Foil

First, connect the new foil coil to an empty core. Make sure the metal rings are on the same
side and connect the coils using the adhesive layer or use a piece of tape. Wind a few turns
of foil to the empty core until the adhesive layer is covered. The foil must be straight and
smooth.
To position a foil, carefully place it on the foil holders as shown below. Make sure that the
foil is mounted with the shiny coated side facing the printhead. Ensure the correct
22
Very poor
Poor
Good
Very good
Excellent
No data available (yet)
Yes
None
Tip: Scan the QR code to access
the demonstrational video

Figure 10: Connecting the Coils

Peleman Industries