Siemens SIMATIC PG 720 P Manual page 76

Configuring the PG 720
"Hardware The following submenu appears when you select the "Hardware Options"
Options" Field
field in the main menu:
Figure 6-7
The parameters of the interfaces present on the basic module are set here.
Configure MPI
Addr. Range
PCMCIA Slot
Programming
interface
Internal COM1
Internal COM2
Internal LPT1
LPT Mode
6-12
PhoenixBIOS Note BIOS 4.0 Setup-Copyright 1985-95 Phoenix Technologies Ltd.
Main Advanced Security Power Savings Exit
Hardware Options
Configure MPI Addr. Range: [Adr. – CC00H]
PCMCIA Slot: [Enabled]
Programming interface: [Enabled]
[3F8, IRQ 4]
Internal COM1:
Internal COM2: [2F8, IRQ 3]
Internal LPT1: [378, IRQ 7]
LPT Mode: [Output Only]
[SIMULTAN]
CRT / LCD selection:
CRT 640 x 480: [75 Hz]
CRT 800 x 600: [75 Hz]
CRT 1024 x 768: [75 Hz]
LCD-Screensize: [Expanded]
Trackball / PS/2 Mouse: [internal]
F1 Help Select Item – / +
ESC Exit Select Menu Enter Select
"PG 740 Hardware Options" Submenu
Entry
Address range in which the multipoint interface is selected.
"0CC00H" or "0DC00H" are memory addresses. The MPI
occupies an address area of 2 KB. "Disabled" enables the address
area and disables the interface.
Enables or disables the PCMCIA interface. PCMCIA occupies the
I/O address range 3E0H - 3E1H.
If the interface is disabled, this area is unoccupied.
Note:
Enables or disables the S5 module interface and the interface for
S7 memory cards. This interface occupies the I/O address range
300H - 31FH.
Enables or disables the COM1/TTY interface
Enables or disables the COM2 interface
Enables or disables the printer port
The mode can be selected here if the LPT1 interface is enabled.
Output Only
Bi-directional
EPP mode
Item Specific Help
Configures the address range
or disables MPI. To prevent
address conflicts, choose
between two different base
addresses.
Change Values F9 Setup Defaults
Sub-Menu F10 Previous Values
Function
Note that PCMCIA cards require
additional card-specific system resources.
Standard mode
Printer port can also be used as an input port or
for EPP support
PG 720 P Programming Device
C79000-G7076-C721-02