Siemens SIMATIC PG 720 P Manual page 11

Changing the With the keyboard open, you can incline the PG 720 to any angle between 0
Angle of
and 90 . To adjust the angle, proceed as follows:
Inclination
1. Lower the keyboard into position.
2. Pull the support (Figure 2-4) out of the rear of the stand and, if necessary,
3. Incline the unit to an angle that will allow you to work comfortably.
Figure 2-2
Note
When you change the angle of inclination, make sure that the keyboard
cable is not trapped between the device and the stand.
Caution
!
Risk of injury!
There is a danger of the unit tipping over if it is set up at an angle of
inclination of more than 15 without using the pull-out support. This could
lead to personal injury and also damage to the unit.
If the angle of inclination is greater than 15 , you must use the pull-out
support and, if necessary, the extra support hoop in the stand.
PG 720 P Programming Device
C79000-G7076-C721-02
pull out the extra support hoop.
Changing the Angle of Inclination
Unpacking and Setting Up the PG 720
SIEMENS
PG 720
Keyboard opened
Pivot
Stand
2-3