Moving The Programming Device - Siemens SIMATIC PG 720 P Manual

Unpacking and Setting Up the PG 720
2.2

Moving the Programming Device

Preparations
The PG 720 is easy to carry. Before carrying it, however, you should take the
following measures:
1. Shut down the operating system. To prevent data loss, you must exit
2. After shutting down the operating system, wait approximately 5 seconds
3. Unplug all the connecting cables.
4. Close the covers protecting the ports and connections on the right-hand
5. Bring the unit into an upright position.
6. Raise the keyboard and lock it by pressing it against the front panel of the
7. If you only want to carry the unit for a short distance, use the handle.
8. If you want to move the PG 720 over larger distances, pack the unit and
Figure 2-6
Carrying the Despite the rugged design of the PG 720, its internal components are
PG 720 sensitive to severe vibration or jolts. When moving the PG 720, you must
therefore make sure that it is protected from severe mechanical forces.
Use the original packing material if you have to ship the PG 720 from one
location to another.
2-6
Windows completely. Windows issues a message to inform you when it is
safe to switch off the device.
before you switch the device off. This allows the drive to come to a
complete stop and ensures optimal protection.
and left-hand side panels.
unit. The latches on the right and left snap in. Make sure that both catches
are properly locked.
all its accessories in the carrying bag supplied.
PG 720 Ready for Transport
PG 720 P Programming Device
C79000-G7076-C721-02