Table of Contents
Advertisement
PG 720 Expansions
Caution
!
Risk of damage!
The electronic components of the printed circuit boards are extremely
sensitive to electrostatic discharge. Certain precautionary measures are
therefore necessary when handling such components. These measures are
explained in the guidelines for handling electrostatically-sensitive devices at
the end of this manual.
Installing the
To plug in expansion submodules, proceed as follows:
DIMM Cards
1. Open the unit as described in Section 5.1.
2. Plug the cards into the slots. Note the safety recess on the connector side
3. Push the card down applying light pressure until it locks into place.
4. Close the unit (see Section 5.6).
Caution
!
Risk of damage!
Make sure that the cards sit securely in the slots, otherwise they can fall out
and be damaged.
Installation
The memory configuration is detected automatically. When you switch on
the unit, the distribution of base and extended memory is displayed on the
screen.
5-8
of the DIMM card.
PG 720 P Programming Device
C79000-G7076-C721-02
Hide quick links:
Advertisement
Table of Contents
