Siemens SIMATIC PG 720 P Manual page 12

Unpacking and Setting Up the PG 720
Detaching the In certain situations, it is helpful to remove the keyboard.
Keyboard
Figure 2-3
Caution
!
Risk of tipping!
If the keyboard is detached, there is a risk of the unit tipping over. Before
removing the keyboard, make sure that you pull out the support from the
device stand (Figure 2-4) and pull out the additional hoop.
Detaching You detach the keyboard as follows:
1. Grip the keyboard hinges in the stand behind the keyboard.
2. Pull the locks in the middle of the hinge assembly towards the keyboard.
3. Pull the keyboard up and out.
4. Place the keyboard on a suitable surface, using the hinge assembly as a
Refitting
You attach the keyboard again as follows:
1. Place the keyboard cable in the cable conduit in the stand.
2. Snap the keyboard hinges into the receptacles in the stand.
Note
When attaching the keyboard, make sure that the cable is lying correctly in the
cable conduit and is fixed in position.
2-4
Press in the catches in the
middle of the hinges
Detaching the Keyboard
stand.
PG 720 P Programming Device
C79000-G7076-C721-02