Siemens SIMATIC PG 720 P Manual page 67

Screen Display With the standard setting of your programming device, the display shown
Following
below appears following power-on:
Power On
Phoenix NoteBIOS 4.0
Copyright 1985-95 Phoenix Technologies Ltd., All Rights
Reserved.
SIEMENS PG 720 P
CPU = xxx*)
0000640K System RAM Passed
0031744K Extended RAM Passed
UMB upper limit segment address: F2xx
Fixed Disk 0: IBM DMCA 21440
Press <F2> to enter SETUP
If you press the F2 key while the above display is shown, you select the
ROM-based BIOS setup program. In this program, you can set a number of
system functions and hardware configurations of your programming device.
The standard settings are effective on delivery. You can change these settings
using the BIOS setup. The modified settings become effective when you have
saved them and terminated the BIOS setup.
The following screen form appears when you start the BIOS setup:
Menu bar
Selectable
submenu
Operating keys
Figure 6-1
*) CPU–Typ
**) MHz (133 or 233 MHz)
PG 720 P Programming Device
C79000-G7076-C721-02
233 MHz**) Mobile
PhoenixBIOS Note BIOS 4.0 Setup-Copyright 1985-95 Phoenix Technologies Ltd.
Main Advanced Security
System Time: [ 15:55:32 ]
System Date: [ 03/01/1997 ]
Diskette A: [ 1.44 MB, 31/2" ]
Diskette B: Not installed
IDE Adapter 0 Master (C: 1445 MB)
IDE Adapter 0 Slave (None)
Video System: EGA/VGA
Memory Cache:
Boot Sequence: [ A: then C: ]
Numlock: [ Off ]
Hardware Options
System Memory: 640 KB
Extended Memory: 31744 kB
F1 Help Select Item – / +
ESC Exit Select Menu Enter Select
Main SETUP Menu
Configuring the PG 720
Power Savings Exit
Item Specific Help
,
Tab Shift-Tab
selects field.
Help window
Change Values F9 Setup Defaults
Sub-Menu F10 Previous Values
, or Enter
6-3