Standard Handset – Up/Down Controls; Upgraded Handset – 4 Memory Preset; Programming Memory Presets; Power Saving Mode – Waking Up The Hand Set - Steelcase Migration Bench SE User Manual

Manual Guide
Standard Handset – Up/Down Controls
Upgraded Handset – 4 Memory Preset

Programming Memory Presets

1. Press the up or down arrow to set the worksurface to the desired height.
2. Press "M" button followed by one of the preset number buttons (1,2 or 3) on
the LED screen.
3. The table will automatically reset to this height whenever the preset number
is pressed and
Power Saving Mode – Waking up the Hand Set
1. Press any button to wake up handset.

Resetting the Base

! Note: Make sure there is nothing under the base before setting to its lowest
22.5" or 57.1cm. If the cable is obstructed it will not reset properly.
1. Press and hold the Down arrow; the desk will begin to go down.
2. Once the desk reaches its lowest height, continue to press the Down arrow
for 5 seconds, until the digital display shows "RST".
3. Release and then press the Down arrow again; the recalibration process will
now begin.
4. When reset is complete, the digital display will show 22.5" or 57.5cm.
A. Up Button
B. Down Button
A. Height Adjustment Buttons
B. Memory Position Buttons
C. Memory Setting Buttons
D. Digital Display
held* until the preset height is reached.