Usb Drive; Data Saving; Restoring Data; Software Update - Wega Wegaconcept Use And Maintenance Manual

Wegaconcept
27

USB drive

The USB drive provided can be used to save all the
settings made on the machine.
If necessary, it's also possible to operate in reverse,
i . e. , l o a d t h e p re v i o u s l y
saved data from the drive to
automatically reset all the
machine parameters.
The various procedures are
described below.
27.1

Data saving

Insert the USB pen in the appropriate
reader (7), and the programming selector
will light up;
press the ( ) key and wait for the data to
be completely saved;
when finished, all the configurations on the machine
will be saved on the USB drive.
SAVING IN PROGRESS
27.2

Restoring data

Insert the USB pen in the appropriate reader (7), and
the programming selector will light up;
press the ( ) key and wait for the data to
be completely loaded;
when finished, all the configurations saved
on the USB drive will be transferred onto the machine.
LOADING IN PROGRESS
38
7
DATA SAVING OK
LOADING DATA OK
!
Do not remove the USB drive during data transfer.
!
If the USB is used with no loaded files, the message
"
INVALID DATA
27.3

Software Update

Through the USB reader you can update the software
on your machine.
Before the update, it is a good thing to prepare the
machine, resetting the counts and alarms.
Proceed as follows:
with the USB drive inserted, turn on the machine while
holding down the ENTER button on the browser;
a message will be displayed to warn you of the success
of the operation, and the machine will boot normally.
The parameters that are re-initialized are:
The alarm page.
The programming of the plans for the intervention of
the A-B-C. services, the count of the strokes carried
out relating to the facilities, and also their total.
The grinders wear alarm and related counts.
!
During the operation, leave the dip switch No.
12 at OFF, otherwise the partial and total counts
(machine life) are also reset.
At this point you can update the software. After
requesting the files to the manufacturer, proceed as
follows:
use a new USB drive;
create a folder named "CMAELITE";
save the unzipped files in .HEX format into this folder;
the file named "QUALIFY.TXT" must also be inserted
into the same file;
update the machine software as described below.
" will be displayed
Technical manual