Table of Contents
Advertisement
NETRONIX
After clearing the memory, apply selected card to module, whenever you like. This
moment, the card becomes "master card". It is impossible to remove or add the
master card by means of other card.
If you want to register a card as a "user card", apply "master card" to reader first,
and next during five seconds, apply registered card.
If you want to remove "user card" from memory, apply "master card" to reader
first, and next during five seconds apply card which is being removed.
After applying to a reader the "user card", the reader enables electric output, which
has been programmed as a controlled by internal access control mechanism.
8. Reset to default settings
To restore default settings, connect reset terminal with ground for 2 s or longer. During
restoring the defaults following reader parameters are fixed:
Parameter name or functionality
Address on serial bus
Baud rate on serial bus
Access password
Port 0
Port 1
Port 2
Port 3
"Autoreader" configuration
Transponder type
Whole internal memory of transponders with
Master card
9. Operation example of transponder
After correct connection of reader and achieving the bi-directional communication
between the reader and master computer, it is possible to perform read-out and write
operation of transponder memory.
Following operation assumes, that reader is in default condition, and applied S50
card is in default condition too. It means this card has full access rights and both 0xff ff
ff ff ff ff keys.
Logging to the reader is to make changes in its factory configuration.
C_LoginUser, 0x31, 0x32, 0x33, 0x34, 0x00
Because during manual experiments, time between subsequent commands sent via
serial interface is large and reaches values from some second to some minutes, it is
required to disable internal UID automatic read-out device.
It should be done by means of command:
NETRONIX
Value or setting
0x01
9600 bps
0x0 - no password
Common purpose input
Common purpose input
lock "on" indication
lock "on" indication
0x2,0x14,0x1,0x1,0x01,0xff
Unique
0xff 0xff 0xff 0xff means "memory
cleared"
CTU-Mxx
.
39
Advertisement
Table of Contents
