Reading-Out The Configuration Of Access Control; Writing The "Automatic Read" Configuration - Netronix CTU-M Series Technical Data Sheet

NETRONIX
Parameter name
C_AccesControlConfigWrite
Mode
Response frame:
C_AccesControlConfigWrite+
Header 1

Reading-out the configuration of access control

5.10.2.
Command frame:
Header C_AccesControlConfigRead
Where:
Parameter name
C_ AccesControlConfigRead
Response frame:
Header C_AccesControlConfigRead+1 Mode
Where:
Parameter name
Mode

Writing the "automatic read" configuration

5.10.3.
This command sets operation method of automatic device, reading the unique
transponder number UID.
The reader described below makes possible to hold-on operation of automatic
device for a while, in case of suitable transmission via serial interface.
If the reader will operate in mixed mode i.e.:
- automatic reading device UID is enabled and:
- master device (computer, controller) communicates with reader or with transponders
via reader,
it is required, to configure the reader correctly, so in case of communication with a
reader or transponder, automatic reading device would hold-on its operation.
Command frame:
Header C_SetAutoReaderConfig ATrig, AMode, AOfflineTime, ASerial, Abuzz CRC
Where:
NETRONIX
Parameter description
Write of access control
configuration.
Operation mode of control
access module.
Parameter description
Read-out of access control
configuration.
Parameter description
Operation mode of access control
module.
CTU-Mxx
Value range
0x74
0x00 – module disabled
0x01 – module enabled
OperationCod CR
e C
CRC
Value range
0x76
OperationCode CRC
Value range
0x00 – module disabled
0x01 – module enabled
.
28