Table of Contents
Advertisement
NETRONIX
Parameter name
C_SetAutoReader
Config
Defines, when automatic reading
ATrig
Lack of transmission can concern
AOfflineTime
Commands for communication
ASerial
Selection the format of sending
MSB
R
AMode
Automatic indication of reading by
ABuzz
means of buzzer, after automatic
UID read-out from transponder.
NETRONIX
Parameter description
Writing the automatic device
configuration.
device UID will operate.
Lack of transmission time on
interface bus
T= AofflineTime * [100ms]
to any commands (Atrig=2), or
commands for communication
with transponder (Atrig=3).
with transponder:
C_TurnOnAntennaPower
C_Select
Automatic sending the UID
transponder number, after
reading it automatically from
transponder.
number
8 bits:
R
H CR R
E
Value range
0-automatic device disabled
permanently
1-automatic device enabled
permanently
2=enabled automatically in case of
transmission lack on interface for a
time longer than AOfflineTime
3=enabled automatically, in case of
no recall of communication
commands with transponder for a
time longer than AOfflineTime
0x00...0xff
0-never
1-for the first applying the
transponder only
2-sends all
R Reserved, always 0
Number which is ended with
CR=1
line end mark CR+LF
information extended with
LSB
E=1
cards umber in filed and card
I
A
type
I=1 Number in reversed order
A=1
Number sent in ASCII format
H=0
A=0
Number sent in Nertonix
H=0
A=0
Number sent in binary format
H=1
0-never
1-for the first applying the
transponder only
2-indicates all
CTU-Mxx
0x58
format
.
29
Advertisement
Table of Contents
