Pursuing The Sector For Given Application; Pursuing The Next Sector Of Application - Netronix CTU-M Series Technical Data Sheet

NETRONIX

Pursuing the sector for given application

5.13.3.
Command frame:
Header C_GetSectorMad
Wherein:
Parameter name
C_GetSectorMad
0xAC
LSB
MSB
Response frame:
Header C_GetSectorMad+1
Notes:
Before you run C_GetSectorMad command:
switch AutoReader mode off (using C_SetAutoReaderConfig command)
• load the keys (using 0xff,0xff,0xff,0xff,0xff,0xff)
• turn antenna supply on (using C_TurnOnAntennaPower command)
• select the card (using C_Select command)
• login to sector with number 0, using key of AA type
If response byte is 0x00, it will mean, that given application is not present in MAD
catalogue.

Pursuing the next sector of application

5.13.4.
Command frame:
Header C_GetSectorMadNext LSB, MSB
Wherein:
Parameter name
C_GetSectorMad
Response frame:
Header C_GetSectorMadNext+1 Sector
Notes:
Before you run C_GetSectorMadNext command, perform sector searching operation
using C_GetSectorMad, command, of which pursuing result was other than 0.
If response byte is 0x00, it will mean, than no more sectors have been found for given
application.
NETRONIX
LSB, MSB
Parameter description
Pursuing the sector
LSB of application number
MSB of application number
Sector
Parameter description
Pursuing the next sector
CTU-Mxx
CRC
Value range
0xAC
0x00 - 0xFF
0x00 - 0xFF
OperationCode CRC
CRC
Value range
0xAE
OperationCode CRC
.
36