Preparing Hot Water; Preparing A Cappuccino; Making A Cappuccino - Krups QUATTRO FORCE A82FD Manual

Place a cup under the coffee outlet. You can lower or raise the coffee outlet to suit the size of your cup (15).
Select your drink and confirm by pressing quickly twice on the confirmation button.
A message will indicate that you have requested two cups.
The appliance will automatically run two complete coffee preparation cycles.
Double cup function (using the double espresso accessory
Your appliance enables you to prepare two cups of coffee or espresso for the following three preparations: espresso/strong
espresso/coffee. This function is not available for long coffee drinks.
Make sure you don't take 2 cups after the first cycle.
You have prepared your appliance. The drinks selection menu has appeared.
Place the double cup accessory under the coffee outlet.
Place 2 cups under the accessory's coffee outlets. You can lower or raise the coffee nozzle with the accessory to suit the size
of your cup.
Select your drink and confirm by quickly pressing twice on the OK button.
A message will indicate that you have requested 2 cups.
Install the steam nozzle on the machine. Select the hot water recipe from the drinks selection menu. A message invites you to
place a container beneath the steam nozzle. You can start hot water production by pressing the confirmation button.
To interrupt the hot water function, simply press any button.
If the nozzle is obstructed, unblock it with the needle provided.
The maximum quantity of water per cycle is limited to 300 ml.
We recommend that you use very fresh, very cold pasteurised or UHT milk, recently opened. Unpasteurised milk does
not produce the best results.
Preparing and installing a milk jug
The milk jug is composed of a plastic container, a lid (including a cassette) and a flexible pipe connecting it to the machine's drinks
outlet. Before the first use, carefully clean the different elements.
Pour milk into the jug (at least 150 ml) (16). Put the lid on the jug by screwing it down with light pressure (17). Lift the locking lever
(18). Install the milk jug on the machine by connecting it to the steam outlet (19), then lowering the locking lever (20). Insert the
flexible pipe into the intended opening in the cassette (21) then place the other end beneath the magnetic drink outlet (22). Ensure
that the system's lid button is in the cappuccino position (23).

Making a cappuccino

While the screen is displaying the drinks selection menu, give a short press (< 3 seconds) on the machine's cappuccino button
(24). A pre-heating phase takes place, then the milk is frothed, and finally the espresso is poured. Your drink is ready (25).
you can interrupt the cycle by pressing OK.
nb the cycle does not stop immediately.
A message appears on the screen telling you to clean the system. We recommend you to carry this out, referring to the
paragraphs CAPPUCCINO SYSTEM RINSING and/or MANUAL MAINTENANCE OF THE CAPPUCCINO SYSTEM.
The machine enables you to set the quantities of milk and coffee according to your desires for a perfectly personalised
cappuccino.
You can alter these settings via the Cappuccino Settings menu.
While the screen is displaying the drinks selection menu, give a long press (> 3 seconds) on the machine's cappuccino button.
1. Select Standard for the factory settings
2. Select New to personalise your recipe. The following stages take place:
a. Pre-heating of the machine
b. Milk frothing phase: press OK when the volume of milk required is reached.
c. Coffee phase: press OK when the volume of coffee required is reached.
The machine will indicate that the new volumes have been recorded for the next cappuccinos.
24

PREPARING HOT WATER

PREPARING A CAPPUCCINO

CAPPUCCINO SETTINGS
)
(1)