CyberData 011309 Quick Start Manual

Singlewire informacast outdoor intercom

The IP Endpoint Company

1.0 Out-of-Box and Prior to Final Installation

1.1. Verify that you have received all of the parts listed on the Installation Quick

Reference placemat.

1.2. Download the current manual, otherwise known as an Operation Guide,

which is available in the Downloads tab at the following webpage:

http://www.cyberdata.net/voip/011309/

Note You can also navigate to the Downloads tab by going to

www.CyberData.net

the following figures:

Singlewire InformaCast

Outdoor Intercom

Part Number: 011309

PoE Switch

Set PoE power type to Class 0 = 15.4W

Quick Start Guide

Singlewire InformaCast Outdoor Intercom

Quick Start Guide

and following the steps that are indicated by

Make sure port is not in trunk mode

Set port to full duplex/ 100Mbps

PoE Injector

CAT6 cable recommended—

for longer distances

Be sure you are using a non-PoE switch or port

930926B

Table of Contents

Do you have a question about the 011309 and is the answer not in the manual?

Page 1 Note You can also navigate to the Downloads tab by going to www.CyberData.net and following the steps that are indicated by the following figures: Singlewire InformaCast Outdoor Intercom Part Number: 011309 2.0 Select Power Source PoE Switch PoE Injector Set PoE power type to Class 0 = 15.4W CAT6 cable recommended—...
Page 2 3.0 Power Test 3.1. Plug in the CyberData device and monitor the LED activity above the ethernet port on the back of the Intercom. See the following figure: 100Mb Link LED Link/Activity LED 3.2. The green 100Mb Link LED blinks off once during the boot up process when the device beings DHCP addressing and autoprovisioning attempts, and then comes on again and remains constant (solid green).
Page 3 4.0 InformaCast Configuration File Retrieval 4.1. DHCP should be enabled. After the device initializes, it will send a broadcast to the DHCP server to ask for the location of its InformaCastSpeaker.cfg configuration file. 4.2. SLP or TFTP? • SLP should be enabled on InformaCast version 5.0.4 or higher. SLP is an InformaCast protocol introduced in InformaCast version 5.0.4.
Page 4 Note You can also access the Technical Support help desk by navigating through menus on the CyberData website (www.CyberData.net) as shown in the following figure: The Technical Support help desk provides the options of accessing documentation for your CyberData product, browsing the knowledge base, and submitting a troubleshooting ticket.